home
 
Manufacturer of "Ready to Run"™ for sheetfed and news web presses featuring new steel cores, specially formulated rubber coverings and bearings mounted to guarantee concentricity. All rollers and blankets are "press ready" and available for immediate shipment from Pacesetter Graphic Service.
Pacesetter carries other press products and supplies: roller cleaner paste, bearings, wash-up blades, and packing paper, etc.

We stock the largest inventory of Heidelberg and Komori inking rollers in the U.K., including Alcolor waterforms and pans, complete with fixtures. Pacesetter lithographic rollers are manufactured completely in-house from new core to rubber cover at our Georgia USA facility which include rubber mills and a machine shop.

 
 
 


 

The Importance of concentricity


What does this mean?

According to the dictionary, concentric means “having the same center”. A very simple definition.
What this should mean to a printer is also very simple: If the rollers you are using are not concentric, they are “defective”.
For a roller to be concentric, all parts of that roller must be made and kept true to the center hole. The original center hole of the journal is machined into the core when it is manufactured. The rubber covering is applied and is built to that same center hole, ensuring the concentricity of the journal “to the core” to the rubber.

The importance of concentricity

If you have a roller recovered just once, there is a 20% chance that it is no longer concentric. The odds multiply each time you have that roller recovered. During the recover process, your core is handled and turned on a lathe several times. Each time this is done, there is one more opportunity for the center hole to be “wallowed out”. Each time a “bearing puller” is used there is a chance of nicking or damaging the uniformity of the center hole.

“Defective” (non-concentric) rollers are the underlying cause of many of the problems that create so much frustration for a printer. If you have ever spent the afternoon chasing “dry-ups” you will know exactly what we are talking about. The lack of concentricity in a roller causes uneven pressure, which in turn causes vibration, which creates heat. These “heated spots” then dry up the fluids near them; thus disrupting your ink and water balance. Premature wear and end-pitting on a roller may also be attributed to the fact that the roller lacked concentricity. Also, you cannot hope to set this “defective” roller correctly if with each quarter turn of the roller, the stripe size varies anywhere from 1/16th of an inch to 1/8th of an inch.

When you consider that it only requires approximately .006 inch movement to create a correct stripe, if you set a roller on the low side and it was out of concentricity by as little as .003 inch you would be squeezing the high side .009 inch. If you set the roller on the high side and it is out enough, this will result in winking. Being out by .003 inch is common on used roller cores; we have seen them out as much as .008 inch.

Of course, if your running your press at only 5,000 impressions per hour, you really don't have anything to worry about. However, if you are a high-speed printer, concentricity is essential to you.

The only way to be sure your rollers are concentric is to start out with a new core and covering every time.